I really appreciate the improvements that have been made in Aerofly FS4, especially regarding the cultivation, the coverage and the added aircraft. However there is one point I am very disappointed: Switzerland. I expect that a newer version of a flight sim, especially when passing a version number, has at least the same quality level but rather better. This is by far not the case regarding Switzerland. Switzerland was a DLC in Aerofly FS2, hence I have paid for it. Now it is included in Europe and free of charge. OK, why not simply move the better swiss images from Aerofly FS2 to Aerofly FS4? I have of course done this, however that does not work as expected because the images from Aerofly FS2 near the border are edited and only sharp on the swiss side of the border. Therefore there are smaler and larger blurred parts near the border.
The following is a comparison of image levels of Switzerland in Aerofly FS2 and Aerofly FS4. As you can see not even L11 does fully cover Switzerland. L12 shows large holes and L13 covers very little where in Aerofly FS2 whole Switzerland is covered by L13. This is very visible when flying over the Alps. Also the L14 coverage is larger in Aerofly FS2.
I would love to have a solution for this. The easiest way would be an unedited collection of the Aerofly FS2 border images. The customers who own the Swiss DLC can then replace the swiss images in Aerofly FS4 with the Aerofly FS2 images and that collection. Or maybe just offer the better swiss quality images from Switzerland DLC of Aerofly FS2 and the edited border images to all.
Aerofly FS2 level 11
Aerofly FS4 level 11
Aerofly FS2 level 12
Aerofly FS4 level 12
Aerofly FS2 level 13
Aerofly FS4 level 13
Aerofly FS2 level 14
Aerofly FS4 level 14