First of all, thank you very much to IPACS and the whole team (Jeff, rodeo, etc., sorry if I miss someone!) for the excellent Geoconvert tool!!.
I have a question: If one selects an extended area (let's say 80 nm x 60 nm) around a certain airport to a resolution level let's say around 3 or 4 (with FSET) and do the complete conversion process, and then AFTER one would like to have a small area around that same airport (let's say 8 nm x 8 nm) to a high resolution level of 0 or 1, and do the conversion process again but only for that small area, the fact that these "two areas" will be overlaping will not create a kind of a conflict inside Aerofly FS 2 or they'll display correctly?.
If someone could clarify this to me I'll be very much appreciated. In case the indicated procedure is not correct, please describe the correct procedure to perform the same task.
Thanks in advance.
Cheers, Ed