User Tools

Site Tools


This is an old revision of the document!


A collision happens when a part of the aircraft contacts the ground surface. When the part is made of rubber and can rotate this usually just fine and preferred over all other parts of the aircraft ;-)

When the part passes through the ground a force is generated which is proportional to the depth below the ground (in meters) times the factor K (N/m) plus the relative velocity (in meters per second) times the factor D (N per m/s). The force acts on the rigidbody assigned in the Body attribute.

A critical crash with any part that is not a wheel can cause the aircraft to be reset, when the designer of the aircraft, us, flags the part as important and sets the CrashOnContact property to true.


            // GA size
                <[tmvector3d][R0][ 0.0 0.0 0.0 ]>

            // airliner size
                <[tmvector3d][R0][ 0.0 0.0 0.0 ]>


Main collision part, uses the mesh of the Geometry from the 3D model to compute collisions with the ground. The coefficients are optional lines of code that can be used to fine tune the friction of the part when skidding across the ground (kinetic) or when stopped (static).

Setting CrashOnContact to false allows the part to contact the ground without an taking damage. This is typically desired for the fuselage to allow the flight to continue after a tailstrikes or a gear up landing and also on the engine cowlings and (lower) wings, when the aircraft lands with gear up or the wing tip just briefly contacts the ground. Parts that contact the ground only in upset attitudes like the vertical stabilizer or upper wings in case of a biplane should always cause a crash on contact.



A spherical object at position R0 with a set Radius that repels the Body from the ground. Used for small skids or a tail gear without a wheel.

                <[tmvector3d][R0][ -0.011895 6.741012 0.065757 ]>


When the geometry contacts the ground a part is damaged, e.g. when the left side propeller disk hits the ground the left side propeller is set to damaged.

This website uses cookies for visitor traffic analysis. By using the website, you agree with storing the cookies on your computer.More information
aircraft/tmd/collision.1563640532.txt.gz · Last modified: 2019/07/20 18:35 by jh